Difference between revisions of "Bridgeport Knee Mill A"
Jump to navigation
Jump to search
(Created page with "400px|thumb =Placeholders= =Guides and Manuals= Link to google drive manuals and docs =Helpful Videos= *How to run a mill *Tubalcain/mrpete22 *...") |
|||
| Line 4: | Line 4: | ||
=Guides and Manuals= | =Guides and Manuals= | ||
*Link to google drive manuals and docs | |||
=General Tips and Safety= | |||
*Wear safety glasses! Chips that come off are hot, and if your whole part comes off it will not be pretty. | |||
*If you need a sharp endmill, you should have your own set. Our tools are shared use and are not always the sharpest. | |||
*Clean and oil the machine's ways and surfaces when you are done | |||
*DO NOT USED COMPRESSED AIR TO CLEAN | |||
* | |||
=About our machine= | |||
*Speed settings are half of what they say | |||
* | |||
=Helpful Videos= | =Helpful Videos= | ||
Revision as of 11:39, 12 May 2018
Placeholders
Guides and Manuals
- Link to google drive manuals and docs
General Tips and Safety
- Wear safety glasses! Chips that come off are hot, and if your whole part comes off it will not be pretty.
- If you need a sharp endmill, you should have your own set. Our tools are shared use and are not always the sharpest.
- Clean and oil the machine's ways and surfaces when you are done
- DO NOT USED COMPRESSED AIR TO CLEAN
About our machine
- Speed settings are half of what they say
Helpful Videos
- How to run a mill
- Tubalcain/mrpete22
- Thisoldtony
- AvE (content warning)